Industry News_Xigu Intelligent Equipment

How to install the ABS sensor ring gear?

How to install the ABS sensor ring gear?

After the ring gear has cooled, it will be tightly stuck in the hub slot. The last remaining task is to use carburetor cleaner to clean the residual waste engine oil on the ring gear. After cleaning, the entire ring gear installation process is completed. .

11

2023

/

10

Roots blower product features

Roots blower product features

Vacuum pump. Due to the pulsation of air flow velocity and pressure caused by periodic suction and exhaust and instantaneous isovolumetric compression, large aerodynamic noise will be generated. In addition, the gaps between the rotors and between the rotors and the cylinder can cause gas leakage, thus reducing efficiency. The exhaust volume of Roots blower is 0.15~150 cubic meters/min, and the rotation speed is 150~3000 rpm. The single-stage pressure ratio is usually less than 1.7 and can be as high as 2.1, and multiple stages can be used in series.

11

2023

/

10

Basic knowledge about ABS brake wheel speed sensor and ring gear!

Basic knowledge about ABS brake wheel speed sensor and ring gear!

The wheel speed sensor is located inside the brake shoe of the axle head and outside the bearing inside the axle head. Corresponding to the wheel speed sensor is the ring gear. When the wheel hub is removed for normal maintenance, the top of the wheel speed sensor and the ring gear are very dirty. Sometimes it may even be contaminated with a lot of grease (butter). In this case, it will directly affect the sensitivity of the wheel speed sensor.

11

2023

/

10

< 1 >

CONTACT US

Tel : +86-15619083491

WhatsApp： +86-18563718697
Email : xgznzb888@126.com
Add : Ronghao Industrial City, Gaoling District, Xi'an City, Shaanxi Province

图片名称

WeChat

图片名称

WhatsApp

GET A FREE QUOTE

Copyright : Shaanxi Xigu Intelligent Equipment Co., Ltd. Powerby : 300.cn jinan2 SEO BUSINESS LICENSE